Slide 1: To check and/or replace brushes: 1. Unplug electrical cord from wall outlet. 2. Slide off the back cover from the dryer. This is a compression fit and will come off with a little effort. 3. Remove all screws on the outside of the dryer that hold the two halves of dryer housing in place. Lay the dryer on its side while removing these screws. Remove the O-ring on the snout of the dryer and lift the top half. 4. Each motor will be sitting in place inside the rubber silicone motor mounts. Removing the rubber silicone motor mounts from the motor is not necessary to replace brushes. The internal filter frame fits into slots on the inside of the dryer housing. This piece can remain while changing brushes. 5. Disconnect motor power wires (see wiring diagram). Note where wires connect.

Slide 2: Motor: (a) Find the flag connector on the top of the brush assembly. There is a wire leading to this connector.

Slide 3: (b) Place a flathead screwdriver with a fine tip between the flag connector and the plastic brush housing.

Slide 4: (c) Rock the screwdriver back and forth and gently wedge the flag connector out of the brush assembly.

Slide 5

Slide 6

Slide 7

Slide 8

Slide 9

Slide 10

Slide 11

Slide 12

Slide 13

Slide 14

Slide 15

Slide 16

Slide 17

Slide 18

Slide 19

Slide 20

Slide 21

Slide 22

Slide 23

Slide 24

Slide 25

Slide 26

Slide 27

Slide 28

Slide 29

Slide 30

Slide 31

Slide 32

Slide 33

Slide 34

Slide 35